Inspect a Forklift
There are more than 10,000 workplace injuries related to forklifts happen every year, according to HRSDC and OSHA reports. A lot of these accidents are caused by driver error. Lack of proper equipment inspection and maintenance results in numerous others. Forklift operation and maintenance is not just the reason for personal injuries, but also of damage to property. Forklifts can damage overhead pipes, sprinklers and building structures, and other machinery when utilized wrongly. The following daily check ups must be performed in order to reduce the chance of forklift mishaps.
Turn the engine off prior to checking different fluid levels: fuel, engine oil, brake fluid, hydraulic oil and coolant. The tires must be inspected for signs of wear and tear. Check the air pressure in the tires. Check the condition of the forks. The load backrest should be attached firmly. Do a visual check of the top-clip retaining heel and pin. Next carry out an inspection of the mast chains, hydraulic hoses, cables and stops. Ensure that the finger and overhead guards are securely attached.
LP forklifts have propane tanks that have to be inspected for signs of corrosion, damage or rust. Test the battery's charge and electrolyte levels. All belts must be inspected for wear. Check to make sure the owner's guidebook is stored on-board the forklift in a storage compartment. Test the seat belt to make certain the latches are secure. Check the hood latch to make sure that it is functioning as it should.
Start the forklift and listen to the noise of the engine to make sure there are no unusual sounds. If there are, investigate at once. Check the steering controls and the accelerator. The parking break and the service break should be correctly working.
To ensure proper functioning in both reverse and forward, the tilt control and drive control must be inspected. The functioning of the lowering control, the hoist and attachment control requires periodic checking. Test the lights and horn. Afterward check the defroster, wipers and heater to make certain they are working smoothly. Inspect each and every gauge to find out that it is reading within functional limits.